Alarming System for Beauty Machines

All beauty machines manufacturered by Stelle Laser has good alarming systems. 

Kindly notice that this alarming system is a system to protect machine to work better and work longer time. It monitoring if every part of machine is in perfect status or not, if there is anything doesn’t accordence with our recommanded, it will start alarming.

Machine alarming doesn’t means machine is broken or machine has problem. On the contrary, it is a way to protect machine better. Alarming means there is something not good for the machine now and you need to adjust and keep machine always in a healthy working status. If use machine in correct way, our machine diode laser never burn and has super long lifespan.

For example, if water impurities start alarming, it means there is too much impurities in the water and this is not good for water. In this case you should change to new water and then use machine.

See below the alarming details and what you should to do:

Alarming system

Icon	Why It Alarms?	What You Should Do It This Alarming
	This is water flow speed alarming.It alarms when the water flow speed is lower than 3.	Change to new water filters, so that the water flow speed will be fast again and stop alarming.
	This is water tempreture alarming.It alarms when the water tempreture is higher than 35 degrees.	Let machine have a little rest. Or calibrate the water tempreture in the machine.
	This is water impurity alarming.It alarms when water is too dirty.	Change to new distilled water for machine.
	This is water level alarming.It alarms when there is too less water in the tank that didn’t covewr the water level sensor.	Open the vent,  add water very full till it over flow from the vent. You should always make sure the water lever is higher than the H level in the tank.
	This is trigger status alarming.It actually will not really alarming. When the trigger is stucked in the handle it will shown as an arrow, and you will be unable to click “Standby”.	If you unable to click “Standby” and this icon shown as an arrow, then it means the trigger is stucked in the handle, you need to release the trigger first, then you can click “Standby” button normally.

If machine starts alarming, please do the step accordingly and machine will back to normal work again.